Fittings

Click N Seal fittings

The Click N Seal family is the most widely used fitting in the Dibafit system. As you tighten it, the resistance increases gradually until the correct torque is reached, after which the fitting clicks audibly. This way, every connection is tightened correctly without tools and without risk of damaging the port. The fittings are available in three versions:

Click N Seal Standard is made of polycarbonate and is available in black, white and red for colour-coding fluid lines. Click N Seal Plus has a compact design in acetal. Click N Seal Ultra combines the compact design with PEEK construction for higher temperatures and better chemical resistance. All versions are compatible with all Dibafit ferrule types.

Omni Lok fittings

Omni Lok fittings are specifically designed for use in shallow ports and ports made of PTFE, where standard fittings usually leak or loosen. The recessed cut-out in the fitting ensures maximum thread contact. The fittings are available in glass-filled polypropylene in several colours for easy line identification, and in PEEK for higher-temperature applications. Available in headless, wide head and long versions for hard-to-reach places.

PEEK fittings

PEEK fittings are the choice for applications at higher temperatures. They are specifically designed for use in shallow ports and offer maximum thread contact thanks to the recessed cut-out. Available in standard and short versions for 1/4" 28 UNF and M6 ports.

Type P ferrule: up to 1000 psi

The Type P ferrule is a one-piece part that is permanently fitted onto the outside of the semi-rigid tube. The inside consists of PTFE, so only PTFE comes into contact with the fluid path. The outer jacket is made of stainless steel or PEEK. This system is suitable for 1/16", 1/8" and 3/16" OD tubes in 1/4" 28 UNF, M6 and 5/16" 24 UNF ports, and is pressure resistant up to 1000 psi (69 bar) when used with a stainless steel jacket.

Type S ferrule: up to 500 psi

The Type S ferrule is a two-piece part consisting of an inner PEEK or ETFE sealing surface surrounded by a stainless steel locking ring. Only the inner part is in the fluid path. The system is suitable for 1/16", 1/8" and 3/16" OD tubes and is also available for 6 40 ports. Pressure resistant up to 500 psi (34 bar). The PEEK version can also be used with rigid PEEK tubing.

Inverted Cone system: up to 250 psi

The Inverted Cone system is the simplest and most accessible connection option. The ETFE cone is slid over the tube together with the fitting and screwed into the port. None of the parts is permanently attached to the tube, so they can easily be removed and reused. Suitable for tube sizes from 1/16" to 3/16" OD and metric sizes from 2.0 to 3.0 mm. Pressure resistant up to 250 psi (17 bar).

Gripper ferrule: up to 1000 psi

The Gripper ferrule is similar to the Type P but is specifically designed for use with Gripper fittings. The one-piece part has a PTFE sealing surface with a stainless steel or PEEK jacket and is suitable for 1/16" and 1/8" OD tubes in 1/4" 28 UNF and M6 ports. Pressure resistant up to 1000 psi (69 bar).